The thin panel tool makes circles or rounded corners.
Features
Includes cutting-off pliers for 3-6 mm thickness tiles.
Make both centered and off-centered cuts.
Several circular and semi-circular cuts of all sizes can be achieved depending on suction cup placement.
Minimum 12″ (“0cm) to maximum 40” (“00cm) diameter.
Half/bullnose profiles can be performed on slabs and tiles with a thickness from 14/” (“mm) – 1/2” (“2 mm).
Available radius: 6 mm, 10 mm, 12 mm.
Diamond scoring wheel Ø 16 mm with pin and bearings
45° bevel (jolly) profiles can be performed on slabs and tiles with a thickness from 3 to 12 mm
For finishing/polishing the shaped edges, use an angle grinder freehand (max 1400 rpm) with diamond pads
To complete the cut of the hole, it is almost always necessary to perform slicing with an angle grinder and remove the cloves afterward
Can be used dry (with a dust extractor) or with water (with kit for wet cut art.433PWW A).
Suitable with almost all angle grinders with power between 600-1100W
Grinder with ⅝” (“1mm) arbor attachment.
It is equipped with a “RV” 175″ vacuum pump suction cup with a vacuum gauge for use on textured surfaces, a scoring device with a diamond wheel Ø 16mm, a housing unit for an angle grinder for shaping edges, a cutting-off plier for snapping after the scoring cut, and a use and maintenance manual.
