Use natural marble, granite, limestone, slate, and travertine.
Features
Advanced penetrating microbond protection
Standard protection against most stains
It makes cleaning stones easier
Preserves natural look
Water-based formula
Interior and exterior
Directions for Use
Allow new grout installations to cure for a minimum of 72 hours before application
Make sure the surface is clean and free of waxes and coatings
Sealer may be applied to damp surfaces 1 hour after standing water is removed
Surface temperature should be between 50°F and 80°F
Ensure that the area is well-ventilated during application and until the surface is dry
Mask any surfaces not intended to be treated
Apply sealer evenly and liberally using a paint pad, roller, or brush
DO NOT APPLY PRODUCT WITH A SPRAYER
Allow sealer to penetrate the surface for 15–30 minutes while spreading excess sealer over the entire area for even penetration
Remove excess sealer by wiping the surface thoroughly with clean, dry towels
Apply the second coat as needed for porous, absorbent surfaces 30–40 minutes after the first coat, following directions in steps 2 and 3
15–30 minutes after the final application, wipe the entire surface with clean, dry towels to remove any excess sealer. To remove any residue, reapply a thin coat of sealer, wait 2–3 minutes, then rub lightly with a white nylon pad. Wipe again thoroughly with clean, dry towels
A complete cure is achieved after 24–72 hours. Foot traffic may begin in 6–8 hours. If needed sooner, cover the floor with red rosin paper to protect it until complete cure is achieved
Clean tools used during application with water
Available Sizes and Coverage
Quart: 10-115 sq ft
Gallon: 50-450 sq ft
5 Gallon: 250-2,250 sq ft
Expected Wear: 3-5 years on interior surfaces and 1-3 years on exterior surfaces
